REDI Drainage Fittings: Solvent-Cement or Rubber-Ring? How to Choose and Install Them
REDI is an Italian maker of uPVC drainage systems, and its fittings are widely specified on Nigerian residential and commercial projects. Most REDI fittings come in two joint types: solvent-cement, often called glue type, and rubber-ring, also called lip-ring or push-fit. Choosing the right one makes installation easier and the system more reliable.
Solvent-cement (glue) fittings
The pipe is pushed into the fitting socket after both surfaces are coated with solvent cement. The cement softens the uPVC and the two parts fuse into one permanent joint.
Best for small waste pipes, typically 32 mm to 50 mm, from basins, sinks, showers and floor traps.
Compact joints, useful in tight ceiling voids and ducts.
The joint cannot be taken apart once it has set, so dry-fit and check alignment first.
Examples: REDI double socket 90 degree bends and sockets with stopper.
Rubber-ring (push-fit) fittings
Each socket holds a rubber seal. The pipe end is chamfered, lubricated and pushed in. The seal keeps the joint watertight while still allowing the pipe to move slightly.
Best for soil stacks, larger waste branches and underground drainage, typically 75 mm to 315 mm.
Allows for thermal expansion, which matters on long runs and on pipes exposed to the Nigerian sun.
Quick to assemble and can be taken apart for changes.
Examples: REDI Y-tees, swept tees, bends and eccentric reducers.
Installation tips for rubber-ring joints
Cut the pipe square and chamfer the end so it does not push the seal out of place.
Clean the socket and seal, then apply a lubricant made for uPVC seals. Do not use oil or grease, which can damage the rubber.
Push the pipe fully home, mark it, then withdraw it by about 10 mm to leave room for expansion.
Support pipes so joints are not carrying the weight of the run.
Installation tips for solvent-cement joints
Use solvent cement made for uPVC and keep the tin closed between joints.
Clean and, if the instructions call for it, prime both surfaces.
Push the pipe in with a slight twist and hold it for a few seconds. Let joints cure before testing.
Fittings that make maintenance easier
Access plugs give a rodding point to clear blockages without cutting pipe. Place them at changes of direction and at the base of stacks.
Non-return valves stop drainage flowing back into a building when an outside drain or public sewer backs up, which is useful in low-lying areas during the rainy season.
Access chambers and floor-trapped outlets complete the system at ground and balcony level.
Can you mix the two types?
Yes. A common layout is glue-type fittings on the small waste branches and rubber-ring fittings on the stacks and main drains. Use the right reducers and adaptors where the two meet, and follow the plumbing designer's drawings.
Buy REDI fittings in Nigeria
Frontier MEPF stocks genuine REDI uPVC fittings from 32 mm to 315 mm at our Lagos store, with prices in naira on every product. See the full REDI drainage range, add items to your quote cart for an instant quotation, and we will deliver across Nigeria.




Comments